MUTOH kona Series User Manual page 166

User's Guide Kona / Kona apparel cutting plotter
Through cutting
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Refer to
166
Set the values for the tool up and tool down distance.
Go to the next sub page

Select Up Dist. and/or Down. Dist.

Enter the desired values and confirm with
Press the test key to verify the quality of the through cutting settings.
The following pattern is cut.
Check if it is easy to push out the cut patterns.
If not, try to increase the force and knife depth

Be sure to perform a sheet-off after the test because the pushed-out squares/circles
will uncover the paper sensor which could lead to an error.
Toolswap settings on page 164
AP-75370 - Revision 1.1