MUTOH kona Series User Manual page 198

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Please find below an overview of the codes and category of problem
A warning means that you will have the choice to continue cutting the current segment, all segments or to cancel the job.

An error means that you will have to retry the scanning routine. The reading of the frame has been cancelled.

Error Message Description
EPOS alignment
6201 EPOS alignment aborted
aborted
EPOS alignment
6202 The pressure rollers are raised
aborted
EPOS alignment
6203 Alignment procedure has been aborted by the user
aborted
6206 Movement failed Movement failed during EPOS routine (moveabsc)
6207 Movement failed Movement failed during EPOS routine (drawcontrol)
6208 Movement failed Movement failed during EPOS routine (scanroutine)
Barcode problem
6211 Barcode too long
occurred
Barcode problem
6212 Barcode width problem
occurred
Barcode problem
6213 Barcode height problem
occurred
Barcode problem
6214 Barcode scan problem 1 (lower line of barcode)
occurred
Barcode problem
6215 Barcode scan problem 2 (upper line of barcode)
occurred
Barcode problem
6216 Checksum not OK
occurred
198
Solution
-
-
Rescan the job and if the error still
occurs, try to:
Replot the job

Reprint the job

Refer to
Bounding box details on
page 152
AP-75370 - Revision 1.1
Category
Error
Error
Error