Toolswap Settings - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Through cutting
7.2.3

Toolswap settings

Step 1:
Step 2:
Note
EasySign always uses SP2 and its own Cut Through parameters.

The user can define his own tool in the user interface (default tool 2) however,

these settings are overruled by the EasySign settings.
164
Press the following buttons in order:
Settings

Tool

next page

Swap alert

Make your preferred choice.
On or Off, if swap alerts is set to off, an automatic switch between tools is

performed without tool swap notifications
AP-75370 - Revision 1.1