Contour Cut, No Bounding Box Found - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting

Contour cut, no bounding box found

When no bounding box is found, you can navigate to a position near the box and restart the automatic alignment again by pressing OK.
Note
It is recommended to navigate to a position at the right side before the box, this because the fastscan starts from this point. If the

position is more to the left and / or directly in front of the box, the fastscan may not find the box.
188 AP-75370 - Revision 1.1