Through Cut Settings - MUTOH kona Series User Manual

7.2.4

Through cut settings

It is however not easy to match an ideal tool configuration setup in which the media weakness
suffers not radically from the multiple cut through samples accomplished. Therefore a perfect
harmony between your tool down force and tool up distance needs to be synchronised.
Via this menu, you can set the desired cut through parameters.
Parameter
Tool
Velocity
Force
Tool Down Distance
Tool Up Distance
Note
Be aware that Software such as EasySign overrules your settings. Therefore it

is best to verify the settings in the used software as well.
After setting these values, it is also possible to test if they match your needs
Follow the procedure below to the velocity and force:
Press the following buttons in order:
Step 1:


Select the tool you want to use.
Step 2:
Set the values for the velocity and force.
Step 3:
Enter the desired values and confirm with
Step 4:
AP-75370 - Revision 1.1
Description
Select the tool you want to use for the cut through operation.
The speed of which the cut through routine is cut. Default: 10 cm/s
The force on the tool during the cut through routine. Default: 250
gram
The distance of cutting through the media. Default: 10 cm
The quantity of media left uncut to hold the sticker fixed to the
media.
Default: 0,1 cm
Settings
Cut through
User's Guide Kona / Kona apparel cutting plotter
Through cutting
7
165