Media Loading Procedure - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Basics

Media loading procedure

Step 1:
Step 2:
Note
In case of working with curled media, refer to

Step 3:
60
Place the media on the media support rolls. Make sure the space between the rolls
is smaller than the diameter of the core. Otherwise, the core will fall through the rolls
when the roll is (almost) empty.
Guide the media under the pressure rollers at the front of the cutter.
Position the pressure rollers (1) so that every pressure roller faces a grit roll (2).
Each pressure roller has a tactile and audible click system which makes it easier to
position them correctly.
Refer to
Pressure roller positioning on page 51
1
2
z
Loading curled media on page 69
AP-75370 - Revision 1.1