Origin - MUTOH kona Series User Manual

Origin

Note
Be aware that this is the customized Origin setting. There is also a standard

origin. For more information concerning the standard origin refer to
page 113
Follow the procedure below to change/control the origin:
Press the following buttons in order:
Step 1:


The following screen is displayed:
Step 2:
Item
Note
When a sheet-off action is performed the origin setting is reset.

AP-75370 - Revision 1.1
Actions
Origin
Information
Move the head to the left
Move the head to the right
Feed the media forwards
Feed the media backwards
Position of the knife tip.
Pressing Cancel after moving the head or the media results in the
head and media returning to its previous position.
Press OK to save the new origin.
User's Guide Kona / Kona apparel cutting plotter
Operation panel
Origin on
4
121