MUTOH kona Series User Manual page 89

Weed out the boxes as shown below, check the patterns and determine which of
Step 4:
them gives best quality. Especially look for good quality of the corners and easy
weeding.
The offset value is larger than the
optimum knife offset
In this case, a square corner is cut as
follows:
The cutting direction is indicated by the
arrow. The corners are not well formed.
The cutter cuts too far in the angular
points.
Note
In case none of the squares shows a good offset, look for the best square,

select this one and perform a new test cut.
Point the knife over the optimum knife offset using the left-right arrow keys and
Step 5:
confirm with
to show the test pattern once more.
AP-75370 - Revision 1.1
User's Guide Kona / Kona apparel cutting plotter
. Use the up-down arrows to move the media forward or backwards
Operation panel
The offset value is smaller than the op-
timum knife offset
In this case, a square corner is cut as
follows:
The cutting direction is indicated by the
arrow. The corners are not well formed.
The cutter did not cut far enough in the
angular points.
4
89