MUTOH kona Series User Manual page 105

Media measure
method
With front
Without front
With front
Uneven media
Without front
Uneven media
AP-75370 - Revision 1.1
User's Guide Kona / Kona apparel cutting plotter
Media measurement
When lowering the pressure rollers, the cutter determines the left, right
and front side of the media.
Next to this, the cutter feeds the media forward.
In case the rear sensor does not longer detect media, the cutter

automatically knows sheet media is loaded.
In case the rear sensor remains covered, the media is fed forward

the set value of the load length.
Refer to
Load length on page 106
The origin is defined from the front of the media.
When lowering the pressure rollers, the cutter determines the left and
right side of the media.
Next to this, the cutter feeds the media forward.
In case the rear sensor does not longer detect media, the cutter

automatically knows sheet media is loaded.
In case the rear sensor keeps covered, the media is fed forward the

set value of the load length.
Refer to
Load length on page 106
The cutter will not feed the media back to the beginning of the media.
In case the front / backside of the media is slightly curled, select this
option. Compared to the setting "With Front" the cutter will feed the
media forward, move the head over the media and determine the left,
right and front side of the media. This way the media is kept flat.
Next to this, the cutter feeds the media forward.
In case the rear sensor does not longer detect media, the cutter

automatically knows sheet media is loaded.
In case the rear sensor keeps covered, the media is fed forward the

set value of the load length.
Refer to
Load length on page 106
The origin is defined from the front of the media.
In case the front / backside of the media is slightly curled, select this
option. Compared to the setting "Without Front" the cutter will feed the
media forward, move the head over the media and determine the left
and right side of the media. This way the media is kept flat.
Next to this, the cutter feeds the media forward.
In case the rear sensor does not longer detect media, the cutter

automatically knows sheet media is loaded.
In case the rear sensor keeps covered, the media is fed forward the

set value of the load length.
Refer to
Load length on page 106
The cutter will not feed the media back to the beginning of the media.
Operation panel
4
105