MUTOH kona Series User Manual page 199

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Error Message Description
Media size Check if the margins left, right, top and bottom are within the specifications.
6218
problem It might be possible that the file you have sent is not correct
Page problem
6221 PG after job failed
occurred
Page problem PG between 2 segments failed or the cutter is set to repeat mode and there
6222
occurred cannot be found a next job.
No EPOS During search with EPOS laser, no edge was found
6223
reference found (colour <> white)
Possible data
6225 One or more frame points lie outside hardclip region. Plot data will be clipped.
clip detected
Print distortion
6226 Original print distortion. No perfect rectangle, no parallel sides (difference > 3mm)
bad rectangle
199
Solution
Did you sent the correct file

Refer to
Bounding box details on
page 152
Check the media size
Refer to
EPOS read on page 138

If this does not help, change the

load mode. This problem could
occur due to the load mode front
and uneven media.
Outer pressure rollers are inside
frame.
Refer to
Loading media on page 51
Bad print quality or outside specs.
Refer to
Bounding box details on
page 152
AP-75370 - Revision 1.1
Category
Error
Error
Error
Warning
Warning