Possibility 1; Possibility 2 - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Basics

Possibility 1

Loading small sized media
Schematic overview Kona / Kona apparel 1650
13
When the media does not reach the second sensor, the second pressure roller will determine
the width of the media.
Position the pressure rollers as follows:
Kona / Kona apparel 1400
Kona / Kona apparel 1650
Note
The third pressure roller must be positioned in the middle of the shaft and has

no influence on the media width.
Refer to
appears.

Possibility 2

Loading medium sized media
Schematic overview Kona / Kona apparel 1650
13
Both sensor 1 and sensor 2 are covered. The media width is determined by pressure roller 3.
Position the pressure rollers as follows:
Kona / Kona apparel 1400
Kona / Kona apparel 1650
Note
Refer to
appears.
52
12 11 10 9
Position pressure roller 2
Pressure roller positioning warning on page 183
12 11 10 9
Position pressure roller 2
Pressure roller positioning warning on page 183
8 7 6 5
2 - 4
2 - 5
8 7 6 5
2 - 4
2 - 5
4 3 2 1
Position pressure roller 3
5 - 7
6 - 8
in case a warning message
4 2
3 1
Position pressure roller 3
5 - 7
6 - 8
in case a warning message
AP-75370 - Revision 1.1