Epos - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Operation panel

Epos

Epos Alignment
This test will fine-tune the position of the cutting knife compared to the EPOS laser. This test
can be done manually and automatically. It is recommended however, to let the Kona / Kona
apparel adjust the values automatically.
Note
It is advised to perform this test for each new knife.

An EPOS calibration is always done with a drag knife. The machine will

automatically check which tools are available and perform the necessary tool
changes to do the calibration. Afterwards, tool changes are done to set the
machine back in the same condition as before.
What tool changes are done, depends on the tool list and the selected location.

Step 1:
Step 2:
Step 3:
98
Start up the cutter.
Install and set a knife.
Refer to
Installing tools on page 40
Install a dark (black) media. Check with the EPOS readout function if it is dark
enough as described in
If no media is loaded on page 138.
AP-75370 - Revision 1.1