Resolution - MUTOH kona Series User Manual

Resolution

Please note that some software packages use the "step per mm" terminology, in which case a
program step of 0.025 mm corresponds with 40 steps per mm and a program step of 0.010
mm with 100 steps per mm.
Contour cutting supports only 0.010 mm program step.
Note
If the plot unit is not set correctly, all your cutting jobs are cut 2.5 times too

large or too small.
Set the resolution as follows:
Press the following buttons in order:
Step 1:



Choose between 0,010 and 0,025 and confirm with
Step 2:
AP-75370 - Revision 1.1
Settings
1x next page
Resolution
User's Guide Kona / Kona apparel cutting plotter
Operation panel
4
111