Operational Problems; Lcm Error Messages - MUTOH ValueCut Series User Manual

7.2

Operational Problems

Some mechanical problems or failure during operation will cause some problems. If the problem
still exists after the recommended actions have been taken, have your cutting plotter serviced.

7.2.1 LCM Error Messages

The error messages shown on the LCM present the problem first, and followed by
recommended actions.
Error, Check Media
Or Drum or X Motor
Error, Check Media
Or Y Motor
Error, Check Carriage
Sensor or VC Motor
Graph Was Clipped.
Data In Buffer
Trouble Shooting
This message indicates that there might be a
problem on the X axis (the media feeding
direction). Check if the drum is working well
and if the media is well loaded. Correct the
problem and re-power on to reboot system.
This message indicates that there might be
an obstruction to carriage relating to a
problem on the Y axis (the carriage moving
direction). Correct the problem and
re-power on to reboot system
This message indicates that the blade
up/down sensor malfunction. Re-power on to
re-boot system. If the problem still exists, find
a serviceman.
This message indicates that the cutting
exceeds the cutting limit. Reload larger media
or re-scale the plot to a smaller size; then
press the key followed by the display of LCM
to continue.
7-2
ValueCut User Manual
.