Service manual Kona cutting plotter
Troubleshooting
6.1.2
Recoverable error messages with no error ID number
During a cutting, measuring or other sequence, it might be possible that one of the below errors occur. Please find a list below with all the possible
errors which can be solved yourself, without any need of an intervention by an authorized Mutoh technician.
Error
EPOS calibration error
<RETRY>
EPOS problem: PG
problem occurred
The plot data is out of
limit and is clipped to
hardclip region
126
Cause
EPOS sensor goes in error during the
EPOS calibration.
When there has been executed a PG
command between 2 segments or at the
start of a new job, this error can occur.
This can be caused by:
Media is too short
Job has been interrupted by the user
A movement cannot be performed
because of mechanical failures.
The data sent to the cutter is larger
than the position between the first
and fourth pressure roller.
Solution
1.
Try again or reboot and try again.
2.
Be sure that there is dark (not red) vinyl installed.
3.
Test the EPOS sensor in Diagnostics mode
Refer to
Menu overview > Actuators on page 115
4.
Replace the EPOS sensor block if it does not work anymore.
Refer to
Penhead assembly > EPOS sensor block on page 50
1.
Check the media size.
2.
Reboot the machine.
1.
Load appropriate media.
2.
Reposition pressure rollers.
3.
Redesign your job.
AP-74380 - Revision 1.1