Rf Section Description; Purpose - Keysight Technologies X Series Service Manual

RF Section Troubleshooting (RF/Microwave Analyzers)

RF Section Description

RF Section Description

Purpose

This section covers only those optional frequency ranges listed below for the
N9010A, Signal Analyzer.
— Option 503, 3.6 GHz Frequency Range
— Option 507, 7 GHz Frequency Range
— Option 513, 13.6 GHz Frequency Range
— Option 526, 26.5 GHz Frequency Range
The RF input signal can be routed through three different front end signal
paths. These various paths are switched in and out based on where the signal
analyzer center frequency is tuned.
1. Low band RF path is used when the input frequency is ≤ 3600 MHz
2. High band RF path #1 is used when the input frequency is > 3.6 GHz to
3. High band RF path #2 is used when the input frequency is > 13.6 GHz to
The RF section is designed to convert RF input signals to an intermediate
frequency (IF) that is present at the RF output of the A13 Front End assembly.
This IF depends on installed options and the IF path selected. This chapter will
assume the default operation in Spectrum Analyzer mode. Therefore, the IF will
be 322.5 MHz.
140
13.6 GHz
26.5 GHz
IF Path
10 MHz (standard)
25 MHz (Option B25)
40 MHz (Option B40)
IF Mode
322.5 MHz Spectrum Analyzer or IQ Analyzer
322.5 MHz IQ Analyzer
250 MHz IQ Analyzer
Keysight N9010A EXA Service Guide