Keysight Technologies X Series Service Manual page 515

Assembly Replacement Procedures
RF Area (Option 532, 544)
Replacement
1. Refer to
2. Refer to
3. Plug in the ribbon cable into the A15 Front End Control assembly.
4. Refer to
Keysight N9010A EXA Service Guide
Figure 15-43. Place the switch onto the bracket and replace the
three screws (1). Torque to 6 inch-pounds.
Figure 15-42. Place the switch/bracket into place onto the
chassis and replace the two screws. Torque to 9 inch-pounds.
Figure 15-41. Install W3, W45, W46, W47, and W48. Torque to
10 inch-pounds.
515