Condition Errors 401 To 499, Power - Keysight Technologies X Series Service Manual

Instrument Messages

Condition Errors 401 to 499, Power

Condition Errors 401 to 499, Power
Errors with signal power unleveled, overloaded, oscillating.
An event with the error number shown in the table means the condition has
been detected.
When the condition is cleared, an event with the error number plus 1000 is
generated.
For example, error 409 indicates a 50 MHz Oscillator Unleveled condition has
been detected, error 1409 indicates that failure has been cleared.
An E in the Error or Warning column means that an error is put up on the front
panel and sent out to SCPI when this condition is detected. A W in this column
means that a Warning is put up on the front panel but nothing goes out to
SCPI. Nothing in this column means nothing is put up; status bit only.
Err# Message
401
RPP Tripped
403
Source Unleveled
405
Source LO Unleveled
407
LO Unleveled
409
50 MHz Oscillator Unleveled
411
50 MHz Input Power too High
for Cal
413
Input Overload
415 unused bit7 is set
417
LO Out Unleveled
419
Preselector Overload
421 unused bit10 is set
423 unused bit11 is set
425 unused bit12 is set
427 unused bit13 is set
429 unused bit14 is set
132
Error or Verbose/Correction Information
Warning
W
W
E
E
E
W
W ADC Input overload
W
Keysight N9010A EXA Service Guide