Keysight Technologies X Series Service Manual page 569

Assembly Replacement Procedures
Fan Assembly
Replacing a Fan
1. Refer to
Figure 15-85 Fan Replacement
2. Position the new fan on the work surface with the arrows pointing to the
3. Orient the fan guard so that the rings are on the outside, and that the "V"
4. With the rivets center posts raised, snap the rivets into place through the
Keysight N9010A EXA Service Guide
Figure 15-85. To replace a fan, it is necessary to remove the 4
plastic rivets (4) that attach the fan (1) and guard (3) to the fan bracket.
To do this use a small screwdriver to unscrew the rivet and remove it from
the bracket.
right and down.
of the support legs are pointing to the neighboring fan.
fan grill and fan bracket and into the fan. Screw the center posts into
place.
569