Bail Handle Removal (Option Prc) - Keysight Technologies X Series Service Manual

Assembly Replacement Procedures
Front Frame Assembly

Bail Handle Removal (Option PRC)

1. Refer to
2. Using the T-20 driver, remove the two screws (3) on each front bumper
3. When replacing these parts, torque to 21 inch-pounds.
Figure 15-89 Bail Handle and Front Bumpers Removal
Keysight N9010A EXA Service Guide
Figure 15-89. Using the T-20 driver, remove the four screws (1),
two on each side, to detach the Bail Handle Assembly (2) from the front
frame.
(4) and remove from the front frame.
575