Front End Controller Troubleshooting Kit - Keysight Technologies X Series Service Manual

Exa signal analyzer, 9 khz - 3.6/7/13.6/26.5/32/44 ghz

Hide thumbs Also See for X Series:

Table of Contents

Service Equipment You Will Need

Front End Controller Troubleshooting Kit

The Front End Troubleshooting kit contains a PC board, required cables, and

installation instructions to verify the switch control logic from the A15 Front

End Control board to the lower level front end components is correct.

Oftentimes when troubleshooting an RF front end problem, the logic needs to

be verified before one of the front end components is changed. This

troubleshooting kit will help identify the defective area in a timely manner. In

order to effectively isolate A15 Front End Control board problems from front

end component problems, it is highly recommended that the N9020-60005

Front End Troubleshooting kit is purchased.

The Front End Troubleshooting kit lower level items can be purchased

individually or as a complete kit with instructions. The complete listing of kit

components, descriptions, and part numbers can be found below.

Keysight Part

Front End Troubleshooting kit

Front End Troubleshooting board

Cable, Low Band switch

Cable, RF Downconverter

Cable, YTF Preselector

Cable, Input Attenuators

Cable, Troubleshooting

Connector, MMCX (f) to SMA (f)

Keysight Part Number

Part of N9020-60005 Troubleshooting kit

www.hubersuhner.com

item number:

31_MMCX-SMZ-50-1/111_OE

Keysight N9010A EXA Service Guide