At Command List - NTT docomo FOMA N702iS Manual

AT Command List

AT commands available on FOMA terminal
d The following abbreviations are used in the AT command list;
[&F] : Command of which setting is initialized by AT&F command.
[&W] : Command of which setting is saved by AT&W command. The setting can be retrieved by
ATZ command.
Modem port command list
The followings are the usable commands for "FOMA N702iS ( モデム )" (modem):
AT command
A/ Executes the last executed
command again. No carriage
return is necessary.
AT
−
AT%V Displays the version of the
FOMA terminal.
n
AT&C Selects the operating
condition of the circuit CD
signal to DTE.
[&F] [&W]
n
AT&D Selects the operation to
take place when the circuit
ER signal received from
DTE transits between ON
and OFF.
[&F] [&W]
n
AT&E Selects how to display the
connection speed.
[&F] [&W]
n
AT&F Restores all of registers to
their defaults. If this
command is input during
communication, the line will
be disconnected.
n
AT&S Sets the Data Set Ready
signal to be output to DTE.
[&F] [&W]
n
AT&W Stores the current settings.
Outline
−
The modem function of a FOMA terminal is
controllable by adding the command of this
table after this command.
* OK is answered even when only AT is entered.
−
n
= 0 ： CD is always ON.
n
= 1 ： CD changes according to the carrier of
n = 0 ： Ignores ER status (always assumed
n
= 1 ： When ER changes from ON to OFF, it
n
= 2 ： If ER changes from ON to OFF, a
n
= 0 ： Displays the wireless network
n
= 1 ： Displays the DTE serial
n
Only
n
= 0 ： DR is always ON (initial value).
n = 1 ： DR signal is ON when the line is
n
Only
46
Parameter/description
the other party's modem (initial value).
to be ON).
becomes an on-line command status.
connection is disconnected and it will be in
an off-line command status (initial value).
transmission speed.
transmission speed (initial value).
= 0 can be specified (can be omitted). (At the time of off-line
connected (when the
communication call is established).
= 0 can be specified (can be omitted). AT&W0
Command execution example
A/
OK
AT
OK
AT%V
Ver1.00
OK
AT&C1
OK
AT&D1
OK
AT&E0
OK
mode)
AT&F
OK
AT&F?
ERROR
AT&F＝?
ERROR
(At the time of on-line
command mode)
AT&F
NO CARRIER
(Change to off-line
mode)
AT&S0
OK
OK
AT&W
OK
AT&W?
ERROR
AT&W＝?
ERROR