NTT docomo FOMA N702iS Manual page 446

Click " ダイヤル " (Dial) and
2
execute access operation
You can leave user name and password blank
for the mopera U or mopera connection. If you
select an Internet service provider other than
mopera U, mopera or you use dial-up
connection, enter the "ユーザー名" (User name)
and " パスワード " (Password) and click "ダイヤ
ル " (Dial).
Check "パスワードを保存する " (Save the
password) to skip entry of the password at
subsequent connections.
Check that the line is connected
3
properly, and click "OK"
Normally, this screen appears when the dial-up
connection is made.
This " 接続 " (Connection) message does not
appear if it has been set to be disabled.
d During packet communication, a different icon appears on the FOMA terminal depending on the
communication conditions.
d
appears on the FOMA terminal during 64K data communication.
NOTE
d When executing data communication by using the FOMA USB Cable (optional), dialing from the dial-up icon is
only valid for the FOMA terminal used when the icon is created.
Therefore, to connect to another FOMA terminal, the communication setting file (drivers) must be installed
again.
(Communicating, sending data)
(Communicating, receiving data)
(Communicating, no data transfer)
(Sending, or disconnecting)
(Receiving, or disconnecting)
25