NTT docomo FOMA N702iS Manual page 298

Table of Contents

Advertisement

Transferring Multiple Data at a
Time
You can exchange multiple data at a time with other
devices.
● When you receive all, all the data on the FOMA
terminal is overwritten by the received data and
registered data are deleted including protected mails
and Secret data of the phonebook. Check if there is
an important data before receiving all the data.
● Transferring all may change the order of data on the
recipient.
Session number
● Transferring all requires the session number to
authenticate the sender and recipient. Before
sending or receiving, the sender and recipient should
agree on a 4-digit number as the session number and
then both enter the same number.
Sending multiple data at a time
<Send all Ir data>
Select "Send all Ir data" from the function menu of
Data list screen or detail screen.
<Example: Send all data stored in the phonebook>
Phonebook list screen (P.105)
1
(FUNC)
"Send all Ir data"
Searching in the phonebook → P.105
Enter your security code
2
session number
"Session number" → P.296
Direct the Infrared data port toward
3
the other party's device
Make sure that the other party's device is ready to
receive all data.
All the data transmission starts.
■ To cancel sending
"NO"
■ To exit during sending
o(Quit)
296
Receiving multiple data at a time
<Receive all Ir data>
1
Receive Ir data screen (P.295)
"Receive all"
Enter your security code
2
session number
"Session number" → P.296
3
Direct the Infrared data port toward
the other party's device
■ To cancel receiving
Press "YES" on the Overwrite
4
confirmation screen
■ To cancel receiving all Ir data
Receive all data from other party's
5
device
All the data reception starts.
■ To exit during the receiving
p
<Forwarding image>
Barring Phonebook Image
Forwarding
Enter
Default setting
When you use the Infrared data exchange or data
exchange (OBEX) to transmit phonebook data, you
can prevent still images stored in the phonebook
from being sent.
"YES"
i
1
"OFF"
■ To forward
"NO"
"NO"
o(Quit)
ON
"Forwarding image"
"ON"
Enter
"YES"

Advertisement

Table of Contents
loading

Table of Contents