NTT docomo FOMA N702iS Manual page 426

Checking the Procedure
In data communication, the connection is made through a dial-up connection with Internet
service providers or LANs that support FOMA data communication.
■ About the "CD-ROM for FOMA N702iS"
d The CD-ROM contains the N702iS communication setting file (drivers), FOMA PC setting software
and FirstPass PC software.
d The N702iS communication setting file is software (driver) needed for connecting the FOMA
terminal with a PC via a FOMA USB Cable (optional) to carry out packet communication, 64K data
communication and data transfer (OBEX). Installing the N702iS communication setting file embeds
each driver into Windows.
Using the FOMA PC setting software, you can easily set up packet communication and 64K data
communication and create a dial-up connection.
Flow chart for completing the data communication setup
This section describes preparation to use packet communication and 64K data communication.
Connect to PC/Install the N702iS communication setting file (drivers)
a Connect the FOMA terminal to the PC with the FOMA USB Cable (optional). → p.6
a Install the N702iS communication setting file. → p.8
<To set up the access point using
FOMA PC setting software>
Install the FOMA PC setting software
a Enables you to use the FOMA PC setting software. "Installing the FOMA PC
Setting Software"→ p.14
<For packet
communication>
Set up
*
a mopera U, mopera
→ p.18
a Other providers → p.20
Connect and disconnect
a Connect → p.24
a Disconnect → p.26
*： To use Internet with the FOMA terminal and PC connected, "mopera U" (you need to apply for) is useful, which supports
broadband connection, etc. Consider the plan in which you are charged only in a month when you use the service. If you
use "mopera" for which you do not need to apply, you can access Internet immediately.
For more information, visit the DoCoMo website.
<For 64K data
communication>
Set up
*
a mopera U, mopera
→ p.22
a Other providers→ p.23
5
<Not using FOMA PC
setting software>
Set up
a Set up communication not using the
FOMA PC setting software→p.30
Connect and disconnect
a Connect → p.44
a Disconnect → p.45