NTT docomo FOMA N702iS Manual page 384

Table of Contents

Advertisement

Problem
The display is dim.
The display and display light of the
keypad do not turn on.
When I receive an incoming call
immediately after turning on the
power, the phone number is
displayed but the name stored in the
Phonebook is not.
It takes some time for the power to
turn on after y has been held
down for 1 second or longer.
Nothing appears on the display.
No incoming call reaction (ring tone
sounding, vibrator, incoming call
lamp flashing) is performed when a
call comes.
The figure of the accumulated charge
does not increase.
When I receive SMS, the name
stored in the Phonebook is not
displayed.
Mails are not automatically filtered.
Mails are not automatically received.
i-mode, i-mode mail, i-αppli or
i-channel cannot be connected.
Even if mail has been received, no
incoming call reaction (ring tone
sounding, vibrator, incoming call
lamp flashing) is performed.
Sent mail does not remain in the
Outbox.
Received mail does not remain in the
Inbox and "
" does not disappear.
" 添付ファイル削除" (Attached file
deleted) is displayed in mail.
Mail sending is interrupted, SMS is
received, and a message appears
when retrying.
Files attached to mail sent from a PC
was deleted.
When shooting pictures, the images
are flickered.
382
Points to check
Is the brightness setting of the display light set to "Level 1"?
Is Lighting of the display light set to "OFF"?
Hold down 5 for 1 second or longer to turn the display light on or off.
Note that the display light turns off when you hold down 5 for 1 second
or longer during operation such as creating a mail.
The FOMA terminal may be reading the FOMA card (UIM) immediately
after turning on the power. The Phonebook function may not be available
during that time.
When Phonebook, etc. has reached full capacity, data verification takes
some time.
The FOMA terminal is in Power saver mode. Press any key to cancel
Power saver mode.
No incoming call reaction (ring tone sounding, vibrator, incoming call lamp
flashing) is performed until the set time has passed when you receive a call
from a phone number not stored in the Phonebook or from a caller who
does not notify its caller ID if "Set mute seconds" of "Ringing time" is set
"ON".
The figure does not increase when it reaches to the limit. Perform "Reset
call duration".
Did you correctly store the phone number of the sender on the phone
number line (
) of the Phonebook?
If the other party's mail address is "Phone Number@docomo.ne.jp",
register the telephone number only in the Auto-sort settings.
If the other party's mail address is other than "Phone Number@docomo.ne.jp",
register the complete address including the domain in the Auto-sort
settings to be automatically allocated.
If you have set "Receive option setting" to "ON", set it to "OFF".
If you have not set "Host selection" to "i-mode", set it to "i-mode" to use the
i-mode.
If you have subscribing to the i-mode Service after purchasing the terminal,
turn the FOMA terminal off and then turn it back on.
Haven't you set "Mail/Msg. ring time" to "OFF"?
Haven't you set "Receiving display" to "Operation preferred"?
Haven't you set "Sort all" to the folder of a mail-connected i-αppli?
Highlight the folder of mail-connected i-αppli and then select "Open folder"
from the function menu to confirm.
Doesn't "
" appear on the folder of a mail-connected i-αppli in the
Inbox? Or, haven't you set "Sort all" to the folder of a mail-connected
i-αppli?
Highlight the folder of mail-connected i-αppli and then select "Open folder"
from the function menu to confirm.
You cannot receive attached files that are not supported by i-mode mail.
Such attached files are automatically deleted at the i-mode Center and you
receive only the message.
When the amount of data communication within a specified time is too
much, the line is interrupted and notified with SMS. Follow the contents of
SMS and the displayed message.
If the image file, attached to mail sent from a device other than the FOMA
terminal is GIF-formatted, only up to 10,000 bytes can be received.
When you take pictures indoors, flickering may appear due to the effect of
fluorescent lighting, etc. The flickering may be suppressed by changing the
"Image tuning" setting.
Ref. page
P.124
P.124
P.109
P.124
P.154
P.314
P.101
P.232
P.224
P.238
P.197
P.117
P.238
P.232
P.228
P.233
P.209
P.163

Advertisement

Table of Contents
loading

Table of Contents