NTT docomo FOMA N702iS Manual page 131

N
If "Pattern 1-3" is selected in the Ring tone settings, the incoming call lamp flashes to the ring tone regardless of the settings of this
function.
If "Melody linkage" is set and there is no vibration pattern stored for melody linkage in the ring tones, the "Standard" pattern is used.
The "Standard" pattern is also used for Chaku-motion.
When multiple mails or Message R/F are received at the same time, the operation of the incoming call lamp becomes as follows:
Received contents
Multiple mails are received
Message R/F are received at the same time
Mail and Message R/F are received at the same time
<Incoming call lamp priority>
When the incoming call lamp settings are duplicated, the priority is assigned as follows:
① Illumination for Utilities→ P.110
② Illumination for Group utilities → P.110
③ Illumination setting
Setting the flashing mode during calls<Illumination in talk>
You can set the flashing mode of the illumination lamps during a voice or videophone call.
i
"Talk" "Illumination in talk" Select any item:
1
OFF......The aqua illumination lamps do not flash.
Pattern 1......The aqua illumination lamps flash in turn at a standard speed.
Pattern 2......The aqua illumination lamps flash in turn more slowly than pattern 1.
......The aqua illumination lamps repeat the following pattern: bottom one lamp lights up → bottom two
Pattern 3
lamps light up → all three lamps light up.
N
When set to the setting other than "OFF", the aqua illumination lamps also flash in turn while the FOMA terminal is holding, on hold or
recording message. However, the flashing pattern for both is set to the same and the illumination lamps flash with a period of 4
seconds regardless of this setting.
Operations of the incoming call lamp
The incoming call lamp setting for the last received mail is used.
The incoming call lamp setting for Message R is used.
The incoming call lamp setting for the last received mail is used.
Default setting
OFF
129