NTT docomo FOMA N702iS Manual page 451

Dial-up creating function
Select the added/edited access point (APN) on the " 接続先（APN）設定 " (Set up Access point (APN))
screen and click "ダイヤルアップ作成 " (Create dial-up).
When the screen for writing into the FOMA terminal appears, click "はい" (Yes). After finishing writing into the
access point (APN), the " パケット通信用ダイヤルアップの作成 " (Create dial-up for packet communication)
appears.
Enter any connection name you want and click " アカウント ・ パスワードの設定 " (Set up Account/Password).
After selecting an available user, enter the user name and password, then click "OK". You can leave the user
name and password blank for mopera U or mopera.
If your provider has given you instructions for setting IP and DNS information, click "詳細情報の設定 "
(Detailed settings) on the "パケット通信用ダイヤルアップの作成" (Create dial-up for packet communication)
screen, register necessary information and click "OK".
After entering the settings, click "FOMA 端末へ設定を書き込む " (Write settings into FOMA terminal), confirm
overwriting and start writing.
NOTE
d The APN settings (the access point for FOMA packet communication) are stored in the FOMA terminal.
Therefore, the APN must be registered again if you connect to another FOMA terminal.
d When continuously using the dial-up setting created on the PC, register the same APN setting (cid setting)
number with the FOMA terminal.
Setting up Dial-up Network
This section describes how to set up a dial-up connection for packet communication / 64K data
communication without using the FOMA PC setting software. The flow of operation is described
below.
d It is unnecessary to set up the dial-up network for 64K data communication. Go on to "Setting up
Dial-up" (p.37).
About AT commands
d AT commands are commands for modem control. The FOMA terminal complies AT commands and
supports some enhanced commands and its own AT commands.
d Entering an AT command allows you to set or confirm (display) the detail settings and the contents
of the settings for the "Data communication" and FOMA terminal.
Checking the COM port
d To set up the access point (APN), you need to specify the COM port number assigned to "FOMA
N702iS" (Modem) built in after installing the N702iS communication setting file (drivers). This
section describes how to confirm the COM port number. The COM port confirmed here will be used
in the access point (APN) set up (p.33).
d Preparation
Connect the FOMA USB Cable (optional) to the FOMA terminal
1
Turn on the FOMA terminal, then connect the FOMA USB Cable
2
connected to the FOMA terminal to your PC
30