NTT docomo FOMA N702iS Manual page 456

Enter the access point (APN)
7
and press
Enter in the format of AT+CGDCONT=<cid>,
"PPP", "APN"
<cid>： Enter any number from 2 or between 4
and 10.
Please be cautious because if cid has been
already set, the setting will be overwritten.
"PPP"： Enter "PPP" as it is.
"APN"： Put " " around the access point (APN)
to enter.
If "OK" is displayed, the settings for the access
point (APN) are completed.
Example: To enter APN named XXX.abc in cid
Number2
Enter AT+CGDCONT=2,"PPP","XXX.abc"
Confirm that "OK" appears and click "ハイパーターミナルの終了 "
8
(Close Hyper terminal) in the " ファイル " (File) menu
""sample"と名前付けされた接続を保存しますか？" (Are you going to save the connection "sample"?)
appears, but it is not necessary to save.
NOTE
d The AT commands entered in "Hyper terminal" may not be displayed after Step 7 on p.35. In this case, if you
enter ATE1 , AT commands you enter from then on are displayed.
d To reset the access point (APN) settings using the AT command
・ If reset, the access point (APN) setting with cid=1 will return to "mopera.ne.jp" (Default value) and cid=3 to "mopera.net"
(Default value), and cid=2, 4 through 10 will be unregistered.
<How to enter>
AT+CGDCONT=
AT+CGDCONT=〈cid〉
d To confirm the access point (APN) settings using the AT command
・ Display the current settings.
<How to enter>
AT+CGDCONT?
Notifying or Not notifying the Caller ID
d You can set whether to notify the other person of your caller ID when packet communication is carried
out. Since the caller ID is important information, please take care when you send your caller ID.
d You can set up the Notify or not notify Caller ID setting using the AT command prior to a dial-up connection.
d Use the ＊ DGPIR command (p.47) to notify or not notify the caller ID or change back to "Not set"
(Default value).
Start "Hyper terminal"
1
Set up Notify (186) or Not notify
2
(184) Caller ID for packet
communication
Enter in the format of "AT ＊ DGPIR=<n>".
To automatically attach 184 (Not notify) for
dialing an outgoing call/answering an
incoming call
Enter the following:
AT ＊ DGPIR=1
To automatically attach 186 (Notify) for
dialing an outgoing call/answering an
incoming call
Enter the following:
AT ＊ DGPIR=2
(to reset all cid)
(to reset a certain cid only)
.
35