Intended Use; Description And Technical Data - Bosch Acu Tank AT 200 Instructions For Use And Maintenance Manual

4 | Low capacity buffers
I. Intended use
The appliance is intended to supply hot wa-
ter to households equipped with a piping
system working at a pressure below 3 bar.
The appliance is intended for work in closed,
heated premises and it is not intended to
work in a constant flow through regime.
II. Description and technical
data
Depending on the model of water heater,
it can have none, one or two built-in heat
exchangers.
T - for temperature indicator (the indicator is
included in the appliance kit) TS1, TS2, TS3
- for mounting temperature sensors for the
tank water that help regulate the flow of the
coolant through the heat exchangers.
Data plate
The data plate is located at the top of the
rear of the DHW cylinder and includes the
following details:
Pos. Description
1 Model designation
2 Serial number
3 Actual content
4 Standby heat loss
5 Volume heated by immersion heater
6 Year of manufacture
7 Corrosion protection
8 Max. DHW cylinder temperature
9 Max. flow temperature, heat source
10 Max. flow temperature, solar
11 Connected electrical load
12 Heating water heat input
13 Heating water throughput for heating water heat
input
14 With 40 °C drawable volume, heated electrically
15 Max. operating pressure, DHW side
16 Highest design pressure
17 Max. operating pressure, heat source side
18 Max. operating pressure, solar side
19 Max. operating pressure, DHW side, CH
20 Max. test pressure, DHW side, CH
21 Max. DHW temperature with electric heating
EN