Product Information; Intended Use; Scope Of Delivery; Product Description - Bosch Stora SWDP 200-2 Installation And Service Instructions Manual

Product information

▶ Follow national and regional regulations, technical regulations and
guidelines.
▶ Record all work carried out.
HHandover to the user
When handing over, instruct the user how to operate the heating system
and inform the user about its operating conditions.
▶ Explain how to operate the heating system and draw the user's
attention to any safety relevant action.
▶ In particular, point out the following:
– Alterations and repairs must only be carried out by an approved
contractor.
– Safe and environmentally compatible operation requires
inspection at least once a year and responsive cleaning and
maintenance.
– The heat generator may only be operated with the casing fitted
and closed.
▶ Point out the possible consequences (personal injury, including
danger to life or material damage) of non-existent or improper
inspection, cleaning and maintenance.
▶ Point out the dangers of carbon monoxide (CO) and recommend the
use of CO detectors.
▶ Leave the installation instructions and the operating instructions with
the user for safekeeping.
2 Product information
2.1

Intended use

DHW tanks made of stainless steel (storage tank) are designed for
heating and storing potable water. Please observe the applicable
country-specific regulations, guidelines and standards for potable
water.
Only install the storage tank in sealed heating systems. All other use is
considered unsuitable. We accept no liability for damage caused through
incorrect use.
The European Drinking Water Directive 98/83/EV from 03.11.1998
applies as framework for potable water.
The following values must be highlighted:
Water quality Unit
Chloride ppm
Sulphate ppm
pH value -
Conductivity μS/cm
Table 26 Requirement for potable water
2.2

Scope of delivery

• Domestic hot water cylinder
• Technical documentation
• Sensor (country-specific)
2.3

Product description

These installation and maintenance instructions apply for the following
product types:
• Storage tank made of stainless steel
– with a heat exchanger: SWDP 200-2/SWDP 300-2
– with two heat exchangers: SWDPS 300-2
Pos. Description
1 DHW outlet
2 Cold water inlet
3 Heat pump return
24
Pos. Description
4
5
6
7
8
9
10
11
Table 27 Product description (
2.4
Pos.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Value
17
<= 250
18
<= 250
19
≥ 6.5... ≤ 9.5
≤ 2500
20
21
Table 28 Data plate
Heat pump supply
TW2 sensor terminal (sensor is not included in the scope of
delivery)
– Install 1x temperature sensor TW2 (top)
TW1 sensor terminal (sensor is not included in the scope of
delivery)
Temperature sensor TW1 (bottom):
– 1x for SWDP 200-2/SWDP 300-2
– 2x for SWDPS 300-2
Adjustable feet
PU insulation
Casing
Solar flow
Solar return

Fig. 1- 4, page 65- 66)

Data plate

Description
Type
Serial number
Useful capacity (overall)
Standby heat loss
Volume heated by immersion heater
Year of manufacture
Corrosion protection
Maximum DHW temperature
Maximum heating water flow temperature
Maximum solar flow temperature
Connected electrical load
Continuous output
Flow rate to reach continuous output
With 40 °C draw-off volumes heated by a booster heater
Maximum operating pressure on the domestic water side
Maximum design pressure (cold water)
Maximum heating water operating pressure
Maximum operating pressure, solar side
Maximum operating pressure on the domestic water side (CH
only)
Maximum test pressure on the domestic water side (CH only)
Maximum DHW temperature with immersion heater
Stora – 6721847474 (2023/02)