Installing And Removing The Ctp( )-U10 Etu - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 110
4. Push the other end down until the locks on both sides click to
hold it in place. Refer to
Until it Locks
Repeat steps 2 and 3, using the slot labeled DSP Module 2, to
install another DSP. Otherwise, you are now ready to install the
drive.
7.3.7

Installing and Removing the CTP( )-U10 ETU

A 4-port CTP( )-U10 ETU must be programmed as an 8-port
CTP-U10 ETU. Ports 5~8 should not be assigned extension numbers
or included in the hunt group.
A 12-port CTP( )-U10 ETU must be programmed as a 16-port
CTP-U10 ETU. Ports 13~16 should not be assigned extension
numbers or included in the hunt group.
1. Make sure the KSU power is off.
2. Install the ETU in the KSU.
3. Turn ON the KSU system power.
4. Wait for the APP1 LED to turn green.
5. Verify that all ports answer.
Figure 6-63 Push Other End Down
Figure 6-63 Push Other End Down Until it Locks
Electra Elite IPK II
Installing ETUs (Circuit Cards)