NEC Electra Elite IPK II System Hardware Manual page 315

Electra Elite IPK II
___________________________________________________________________________________
LED
LED 17, CH8
The following LEDS are also used during startup to signify:

LED 1 - BICOM driver loaded
LED 2 - Scandisk completed successfully
LED 4 - Application started successfully
After the system is up and running these LEDs are turned off, and all channels are ready to

receive calls.
When the VMP(4)/(8) fails to start, all eight channel LEDs and the BCLR LED (AP1) are on.

___________________________________________________________________________________
System Hardware Manual
Table 6-66 VMP(4)/(8)-U( ) ETU LED Indications (Continued)
Description
Off/On-Hook status
Table 6-67 VMP(4)/(8)-U( ) ETU Ready LED Indications
status of the VMP(4)/(8)-U( ) ETU after it has been installed,
initialized, and is ready to process calls.
Table 6-67 VMP(4)/(8)-U( ) ETU Ready LED Indications
LED 1, AP1
Application Software
LED 4, CF PWR
LED 5, ICGA
LED 7, Shutdown
LED 8, Power
8.9.5 Jumper Settings
The following jumper settings apply.
J1
Pin 1 to Pin 2
Pin 2 to Pin 3
On
Red for Off-Hook
LED Description
Running without
Power to the ETU
Live LED
Initialized
application
Receiving KSU
IVR Integration (default)
Not Used
Document Revision 3
Flashing
Not Used On-Hook
shows the
Status
Solid Green
errors
Solid Red
Blinking Red
Solid Green
Solid Red
power
Setting
Off
6 - 173