Document Revision 3
___________________________________________________________________________________
S
11
A
ECTION
DJUSTING THE
The base plate on the Multiline Terminal is hinged to allow the height of the terminal
to be raised or lowered.
1.
2.
3.
___________________________________________________________________________________
8 - 26
H
EIGHT ON A
Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to
DTH/DTR/ITH Multiline
Figure 8-31 Raising the Height on the DTH/DTR/ITH Multiline Terminal
After the height is adjusted, pull the line cord though the groove in the bottom of
the Multiline Terminal and adjust it.
Push on the adjustment tabs on the side of the stand and push down to lower
the base plate. Refer to
Terminal.
Figure 8-32 Lowering the Base Plate on the Multiline Terminal
M
T
ULTILINE
ERMINAL
Figure 8-31 Raising the Height on the
Terminal.
Figure 8-32 Lowering the Base Plate on the Multiline
Installing Electra Elite IPK Multiline Terminals
Electra Elite IPK II