Document Revision 3
___________________________________________________________________________________
LED 3 (DS13)
LED 2 (DS12)
LED 1 (DS11)
___________________________________________________________________________________
6 - 164
Table 6-60
LED
Description
Conference Status
(Back of ETU)
Insertion Status
(Back of ETU)
Boot Status
(Back of ETU)
8.6.5
Connectors
The following connectors are used:
J1 Ethernet Connector
This connector is a single 10/100 MPS Ethernet Connector.
This port has Auto-Medium Dependent Interface Crossover
(MDIX) to allow using either a straight-through Ethernet cable
for connection to a PC or a crossover Ethernet cable.
The Ethernet Interface setting allows manual configuration of
the Ethernet port from the Web Interface, and can be set to
operate in the following port speed and duplex mode
combinations: 10MB/Full Duplex, 10MB/HalfDuplex,100MB/
Half Duplex, or 100MB/Full Duplex, Auto-Negotiate.
J2 Serial Connector
This 10-pin serial terminal is used for debugging operations
only.
CNF(16)-U20 ETU
LED Indications
On
Conference Initialized
Insertion Complete
Boot Complete
Electra Elite IPK II
Off
Conference not
Initialized
Insertion not
Complete
Boot Incomplete
Installing ETUs (Circuit Cards)