NEC Electra Elite IPK II System Hardware Manual page 442

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
9 - 36
3. Press Hold, Transfer, , and # to enter the basic programming
mode.
4. The Programming Menu is displayed. Press 1 to display the
Network Settings options. This enables you to configure IP
settings for IP Terminals.
5. Press 1 (DHCP mode is displayed). Press the corresponding
digit ( 1 or 2 ) to enable or disable DHCP mode; then press the
softkey that corresponds to Set on the LCD.
6. When DHCP is not used (Static IP assignment), select 1
(Disable), then select Set , and proceed to step 7. When DHCP
is used, select 2 (Enable - factory default) and proceed to step
10.
7. From the Network Settings option, press 2 and enter the IP
Address (XXX.XXX.XXX.XXX); then press the softkey
that corresponds to Set on the LCD.
8. From the Network Settings option, press 3 and enter the
Subnet Mask (XXX.XXX.XXX.XXX); then press the softkey that
corresponds to Set on the LCD.
9. From the Network Settings option, press 4 and enter the Router
IP Address (XXX.XXX.XXX.XXX); then press the softkey that
corresponds with Set on the LCD. To return to Programming
Menu , press the softkey that corresponds to Prev on the LCD.
10. Press 2 from the Programming Menu to access the MGC
(Media Gateway Controller) IP Address and enter the IP
Address for IAD(8)-U( ) or PVA ETU Megaco Station
(XXX.XXX.XXX.XXX); then press the softkey that corresponds
to Set on the LCD.
11. Press 3 from the Programming Menu to access the Extension
Number option. Enter the extension number and press the
softkey that corresponds to Set on the LCD.
12. The extension number is used to register the IP terminal with
the IAD(8)-U( ) Megaco Station Card or PVA ETU. These
settings must match the Electra Elite IPK II Programming
Station Number Assignment in PRG 11-02. This entry is
required if DHCP mode is enabled .
Installing Electra Elite IPK II Optional Terminal Equipment
Electra Elite IPK II