Connectors; Jumper Settings - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 96
7.1.5

Connectors

The following connectors are included:
J2 and J3
Used to install the MDM-F-20 Unit.
J9
Connects to the backplane.
9-pin RS-232 (COM2)
Connector is not used (MDM-F-20 Unit).
RJ-11 modem port (COM2)
Remote connector on serial interface (MDM-F-20 Unit).
9-pin RS-232 (COM1)
Local serial connector on main ETU for direct connection.
7.1.6

Jumper Settings

J1
Pin 1 to Pin 2
Pin 2 to Pin 3
7.1.7 Connectors
The following connectors are included:
J2
J6
J10
J11)
J12
Used only on FMS/CMS
No external modem connected (default)
External modem connected
Connects to the backplane.
Used for Compact flash drive on FMS.
Not used.
COM port for console programming connection
Port expansion connector for DSP-U30
Electra Elite IPK II
Installing ETUs (Circuit Cards)