Charging The Headset Battery; Initial Setup; Using The Headset; D Term ® Cordless Ii Terminal - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
5.4
5.5
5.6
S 6 D
ECTION
6.1
___________________________________________________________________________________
13 - 10

Charging the Headset Battery

To charge the headset battery, place it in the docking cradle. During charging,
the charge indicator is On. When charging is complete the indicator goes Off.
The headset must be charged for a minimum of one hour before use – three
hours to fully charge.

Initial Setup

The Unit includes a ringer in the base to provide notification of an incoming
call when not wearing your headset. This feature is enabled when the Ringer
switch is down and is disabled when the switch is up.
When the headset is installed, it sets itself as the default device in your
computer. You can set your preferences manually in Windows through the
Sounds and Audio Devices option in the control panel. A softphone may
require choosing the audio device and carries out a short test to match this
device to the softphone. It may also enable you to choose which device
indicates an incoming call. Refer to the softphone documentation for more
information.

Using the Headset

Refer to the User Guide for operating procedures.
term ®
C II T
ORDLESS

Description

term
The D Cordless II terminal uses 900 MHz Digital Spread Spectrum (DSS)
Technology and is connected in tandem to a Multiline Terminal. The terminal
has a 16-digit, 2-line LCD, dial pad, talk key, chan key, hold key, transfer key,
conf key, mute key, vol key, a msg icon, vibrator, and four function keys with
red LEDs.
In an ideal state, this terminal can be switched between cordless and the
Multiline Terminal connected to it using Cordless or Desk key on the base unit.
ERMINAL
Installing Cordless and Wireless Telephones
Electra Elite IPK II