External Recording System Or External Ringer - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
6.9
___________________________________________________________________________________
System Hardware Manual
6.8.2 Connecting a Dry Contact Relay Device to the
Make sure the jumper in the PGD(2)-U10 ADP for the channel is set
correctly. (Refer to
1. If a line cord was not previously connected to the
, complete Steps 2~5. Otherwise, skip to Step 6.
ADP
2. Install a modular jack for each
24 AWG station cable from the crossconnect block to a
modular jack. Ground the unused pair.
3. Terminate the extension leads to GRN/RED of the modular
jack. Terminate the unused leads to the jack.
4. Install bridging clips as required.
5. Plug a modular line cord from the mod jack to the CN1
connector on the
6. Connect the two-conductor station cable from the CN5
connectors in the
The relay closes when the Door Box/external page zone is
called. The maximum applied voltage is 24vDC at .5A for each
contact.

External Recording System or External Ringer

The allows for the connection of an external recording system
PGD(2)-U10 ADP
or external ringer.
1. Make sure the jumper in the
correctly. (Refer to
2. If a line cord was not previously connected to the
complete Steps 3~6. Otherwise, skip to Step 7.
3. Install a modular jack for each
station cable from the crossconnect block to a modular jack. Ground the
unused pair.
4. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
5. Install bridging clips as required.
Figure 7-6 Jumper
PGD(2)-U10 ADP
PGD(2)-U10 ADP
PGD(2)-U10 ADP
PGD(2)-U10 ADP
Figure 7-6 Jumper Settings).
PGD(2)-U10 ADP
Document Revision 3
PGD(2)-U10 ADP
Settings).
PGD(2)-U10
. Run one-pair
.
to the external relay.
for the channel is set
PGD(2)-U10 ADP
. Run one-pair 24 AWG
,
7 - 17