Inserting An Etu Into The Ksu Slots - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
2.2
___________________________________________________________________________________
6 - 4
When you set switches on the ETU, wear a wrist strap and stand on a
grounded conductive work surface to avoid static electricity.
Figure 6-4 Safety Precautions when Setting Switches on an ETU
Do not touch the surface of the ETU. A small screw driver can be used
to change the switch settings when the installer follows the
recommended safety precautions.

Inserting an ETU into the KSU Slots

1. To unlock the ETUs slots, move the slide bar to the left.
2. Slide the ETU into the proper slot in the KSU.
3. After the ETU is pushed all the way to the back of the KSU, move the
slide bar to the right to lock the ETU slots.
If inserting multiple ETUs, wait approximately 15 seconds between each ETU
and move the slide bar right after the last one is installed.
Electra Elite IPK II
ETU
Wrist
Strap
Grounded
Conductive
Surface
Installing ETUs (Circuit Cards)