Switch Settings - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 132
7.5.6

Switch Settings

Table 6-42 VMP( )-U40 ETU Switch Settings
Reset Power Switch SW1
DIP Switch SW2
1 2 3
ON
ON ON
ON
ON
ON
Switch SW3 Positions
RUN
SHUT DOWN
Used for development only
4
Enable HostKey and run Manufacturing Test (NEC
Production use only.
Enable HostKey with floppy disk redirection and run
Manufacturing Test (NEC Production use only).
Connect to Cosession using modem instead of direct
cable.
ON Start BRU host with direct cable connection
ON Start BRU host with modem connection
Connect to Cosession using direct cable connection,
ON but do not start voice mail software (for
troubleshooting and maintenance only).
Used to identify ETU operation
LED 6 is on red.
LED 7 is on red.
Electra Elite IPK II
Description
Installing ETUs (Circuit Cards)