Adding A Blade; Removing A Blade - NEC SL1100 Pc Programming Manual

Issue 3.01
___________________________________________________________________________________
___________________________________________________________________________________
4 - 24
3.3.1

Adding a Blade

To add a blade, complete the following steps:
1. With the mouse, right click on the slot where you want the blade
to reside.
2. A popup menu appears listing the blade types that can be
installed. There are two additional options on the popup menu.
These are Configure Card and Delete Card. Note that these two
options are only available if a blade has previously been added.
3. Select a blade type relevant to the blade to install.
4. Another popup menu appears listing blades associated with the
selected blade type.
5. Select the desired blade package you want to add. The slot
changes appearances indicating the blade installed, the firmware
version being used, the port type, and the port range being used.
3.3.2

Removing a Blade

To remove a blade, complete the following steps:
1. With the mouse, right click on the blade you want to remove.
2. When the popup menu is displayed, select Delete Card. The
blade is removed and the slot and port type range it was utilizing
is now available for use by another blade.
NEC SL1100
Standard View