Installing The Ad(A)-R Unit On A Multiline Terminal - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
9 - 12
To provide control to the recorder or to enable/disable the record
start warning tones, refer to
Switch
SW1-1
SW1
SW1-2
SW2-1
SW2
SW2-2
DSW 1
DSW 2
Dip
DSW 3
Switche
and
s
DSW 4
(DSW)
DSW 5
DSW
6~8
Do not connect T1 and T2 when DSW switches 3 and 4 are On.

3.2.3

Installing the AD(A)-R Unit on a Multiline Terminal

The AD(A)-R Unit should be installed after the cables are connected
and the switches are set.
If wall mounting the Multiline Terminal, a WM-R Unit must be used.
Refer to
1. Unplug the telephone cord (and the AC-2R/AC-3R Unit cord if
installed) from the Multiline Terminal.
Installing Electra Elite IPK II Optional Terminal Equipment
Table 9-2 AD(A)-R Unit Switch
Table 9-2 AD(A)-R Unit Switch Settings
Description/Settings
Connects to Multiline Terminal
Connect = Default
Not Used
Sets External Equipment Impedance to 600 Ω
Used for Complex Impedance Devices
(< 30 Ω Input Impedance)
Output Hook Signal to External Device
On = Output
Off = No Output (Default)
Record Confirmation Tone
On = Tone On
Off = Tone Off (Default)
Use T1/T2
On = Disable (Default)
Off = Enable
Reset Signal Upgrade
On = Normal (Default)
Off = Debugging
Firmware Upgrade
On = Firmware Upgrade
Off = Disable (Default)
Section 13 Wall Mounting Multiline Terminals on page
Electra Elite IPK II
Settings.
8-29.