NEC Electra Elite IPK II System Hardware Manual page 370

Document Revision 3
___________________________________________________________________________________
S 5 C
ECTION ONNECTING AN
These instructions for connecting an IP Multiline Terminal to the Network and PC
apply to ITH-8D/16D-2/3 Multiline Terminals. Refer to
Connector
1.
2.
Refer to
to LAN
___________________________________________________________________________________
8 - 18
IP M
ULTILINE
Locations.
Connect the LAN Network 10/100 Base-T cable to the LAN (=) connector.
The IP terminal has a switching HUB to connect a PC to the LAN Network.
Connect the 10/100 Base-T/TX straight cable used for this connection to the
PC(x) connector and to the PC.
Figure 8-19 Typical Network IP
REAR VIEW
Note: The PC connector on the IP terminal is exclusively for a PC connection, not a second IP
terminal.
Figure 8-18 IP Terminal Rear Connector Locations
T N
ERMINAL TO THE
Figure 8-18 IP Terminal Rear
Connection.
Installing Electra Elite IPK Multiline Terminals
Electra Elite IPK II
PC
ETWORK AND
to PC