Electra Elite IPK II
___________________________________________________________________________________
Notice the four pins to
the left of the drive.
These pins are not
connected for normal
operation.
___________________________________________________________________________________
System Hardware Manual
Figure 6-72 Connecting the Ribbon Cable
6.
Place hard drive on table with printed circuit board side up and
the pins facing the card as shown in
the Ribbon
Cable.
7.
Connect the hard drive to the cable making sure that the four
pins on right side of the drive are not connected as shown in
Figure 6-73 Leaving Four Pins
Document Revision 3
Red Stripe
Figure 6-72 Connecting
Unconnected.
6 - 127