Installation; Keypad Functions - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
9 - 66
3.11.2

Installation

1. Connect the provided 25' Cat. 5 cable between the LINK OUT
jack of the base unit and the LINK IN jack of the conferencing
pod.
2. Connect the provided RJ-11 cable between the base unit and
the telephone jack.
3. Connect the power cord to the base unit and plug it in an
electrical outlet.
4. To connect additional units, connect a 12' Cat. 5 cable between
the LINK OUT jack of the unit connected to the base unit and
the LINK IN jack of the second unit and repeat the connection
of another 12' Cat. 5 cable between the LINK OUT jack of each
unit to the LINK IN of the next unit in sequence.
3.11.3

Keypad Functions

Refer to Table 9-13 Keypad
Key
ON/OFF key
(telephone icon)
PHONEBOOK (book
icon)
REDIAL (circular arrow
icon)
CONFERENCE (three
person icon)
FLASH (lightning flash
icon)
CLEAR ( vertical line
and left arrow icon)
VOLUME (loud and
dim speaker icons)
MUTE (mike with
diagonal line icon)
Installing Electra Elite IPK II Optional Terminal Equipment
Functions.
Table 9-13 Keypad Functions
Function
Press to activate the telephone and access dial tone.
Press again to hang up and return to standby mode.
Press to dial stored numbers. Press and hold two
seconds to enter Phonebook Edit mode.
Press once to dial the last number called. Press and
hold two seconds to enter Program mode.
Press to dial the conferencing service provider. This
feature must be programmed.
Press to enable call forwarding, call waiting, or
three-way calling when supported by telephone
service.
Press to clear the last digit entered or press and hold to
clear all numbers.
Press to exit programming mode.
Press during call to adjust call volume or press while
telephone is ringing or in standby mode to adjust ringer
volume.
Electra Elite IPK II