Installing The Cta-U Unit - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
11 - 22
The CTA-U Unit is attached to the bottom of any DTU/DTP Multiline Terminal
except DTP-2DT-1 and DTP-16HC-1.
(AC Adapter)
3.5.1

Installing the CTA-U Unit

1. Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter
2. Plug the unit into the receptacle connector inside the base plate
on the Multiline Terminal. Refer to
Unit to the Multiline
Figure 11-27 Attaching the Unit to the Multiline Terminal
3. Close the base plate.
ACA-U Unit
Figure 11-26 CTA-U Unit
Terminal.
Installing Electra Elite Optional Terminal Equipment
Electra Elite IPK II
Installation.
Figure 11-27 Attaching the