Trunk Etus; Brt(4)-U( ) Etu; Description - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
S 5 T
ECTION RUNK
The Electronic Telephone Units described in this section provide a link between
trunks in the Electra Elite IPK II system and outside equipment. All ETUs are installed
in the interface slots of the KSU.
5.1
___________________________________________________________________________________
6 - 20
ETU
S

BRT(4)-U( ) ETU

5.1.1

Description

The Basic Rate Trunk (BRT) Interface ETU terminates ISDN Basic
Rate Trunk lines and supports four ISDN-BRI circuits. Each trunk
supports two B channels. These eight B channels can be used for
CO trunks with DTMF signaling. Tip and Ring electrical fuses are
provided to comply with UL 1459 requirements.
This ETU uses an S/T-type interface. When connecting to a CO, a
locally provided Network Termination unit (NT1) is required. Caller
ID is supported.
One BRT ETU provides a maximum of four ISDN circuits that
provide eight B channels to be used as trunks.
Figure 6-10 BRT(4)-U10 ETU
Installing ETUs (Circuit Cards)
Electra Elite IPK II