NEC Electra Elite IPK II System Hardware Manual page 508

Document Revision 3
___________________________________________________________________________________
6.
7.
8.
___________________________________________________________________________________
11 - 4
When an adapter is being installed, press tabs A and B to remove the dummy
end from the base plate as shown in
End.
Figure 11-5 Removing Base Plate Dummy End
Cut the dummy end in half as shown in
Figure 11-6 Cutting Dummy End in Half
When the adapter is installed in connector 1 as shown in
Adapter in Connector
Installing Dummy End
Figure 11-5 Removing Base Plate Dummy
Figure 11-6 Cutting Dummy End in
1, Install the dummy end B as shown in
B.
Installing Electra Elite Optional Terminal Equipment
Electra Elite IPK II
Half.
Figure 11-7 Installing
Figure 11-8