Connectors - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 134
Table 6-44 VMP( )-U40 ETU LED Indications (on back of ETU)
LED No.
12
13
14
15
16
17
CH LEDs 1~4 light during startup to indicate:
LED1 BICOM driver loaded.
LED2 Scandisk completed successfully.
LED3 CoSession Host loaded successfully.
LED4 Voice Mail started successfully.
After the system is up and running these LEDs are off, and channels

can receive calls.
When Voice Mail fails to start, all CH LEDs and the AP1 LED are on.

7.5.9

Connectors

Table 6-45 VMP( )-U40 ETU Connectors
Connector
CN2
CN4
CN6
CN8
CN9
CN11
CN12
Name On
CH3 Red (Off-Hook)
CH4 Red (Off-Hook)
CH5 Red (Off-Hook)
CH6 Red (Off-Hook)
CH7 Red (Off-Hook)
CH8 Red (Off-Hook)
Backplane connector
SO-MIDD memory connector
Compact Flash Connector
Hard Drive connector
Ethernet Port
COM port for console programming connection
Port expansion connector for DSP-U30 Unit
Electra Elite IPK II
Flashing
Not Used On-Hook
Not Used On-Hook
Not Used On-Hook
Not Used On-Hook
Not Used On-Hook
Not Used On-Hook
Installing ETUs (Circuit Cards)
Off